Icom FR6000 Series Sales Handbook - page 19
UR-FR5000/UR-FR6000 Installation
INSTALLATION
INSTALLATION
INSTALLATION
INSTALLATION
• Install the UR
• Install the UR
• Install the UR
• Install the UR----FR5000 or UR
FR5000 or UR
FR5000 or UR
FR5000 or UR----FR6000(channel
FR6000(channel
FR6000(channel
FR6000(channel
extension module)
extension module)
extension module)
extension module)
1
Attach the supplied angles to both sides of the
channel extension module, and tighten the 2 supplied
screws (M4
×
8) on each side.
2
Install the channel extension module using the
supplied screws (Tapping screws: M3
×
8, Set screws:
M3
×
6) as shown below.
Set screws
Tapping
screws
Channel extension
module
Channel module
(original)
ASSEMBLE THE UNIT
ASSEMBLE THE UNIT
ASSEMBLE THE UNIT
ASSEMBLE THE UNIT
1
Replace the rubber seal and shielding plate of the
front panel, then tighten the 6 screws.
• Make sure the rubber seal is properly seated in the
groove of the chassis.
• Be sure to match the correct positions of the holes
of the shielding plate and projections of the front
panel’s chassis.
2
Connect the control cables to the channel modules.
Channel extension module
Channel module
(original)
Projections
Rubber seal
Holes
19
• Connect the control cable
• Connect the control cable
• Connect the control cable
• Connect the control cable
1
Connect the supplied control cable to J502 on the
front board as shown below.
2
Cut the rubber caps of the control cables, then
insert the rubber caps to the front panel’s chassis
as shown below.
3
Return the front panel, top cover and screws to their
original positions.
(original)
Shorter cable
(lower side)
Longer cable
(upper side)