Intermec EasyCoder PD4 Installation Instructions

Manual is about: ESim v5.12 Bar Code Label Printer

Page of 4

Download

Bookmark us

EasyCoder

PD4/PD41/PD42

Thermal Printhead (200/300 dpi) Installation Instructions

These instructions tell you how to install a 200 dpi or 300 dpi thermal

printhead in an EasyCoder PD4/PD41/PD42 printer. The kit contains the

following:

• 200 dpi or 300 dpi thermal printhead

• Printhead adapter printed circuit board (PCB)

Required Tools

To install the interface board in your printer, you need these tools:

• Screwdriver, slotted

• Screwdriver, Phillips (with magnetic tip)

Installing the Thermal Printhead and the Adapter PCB

Before you begin installation, please acknowledge the following important

safety notes:

Make sure the printer has been turned off and

disconnected from the power supply before you

start installation.

Stellen Sie sicher, dass der Drucker abgeschaltet

und von der Stromversorgung abgetrennt wurde,

bevor Sie mit der Installation beginnen.

Take precautions against electrostatic discharge, for

example, by wearing grounded wrist straps.

1 2 3 4 Next › »

Page 1
Easycoder ® pd4/pd41/pd42 thermal printhead (200/300 dpi) installation instructions these instructions tell you how to install a 200 dpi or 300 dpi thermal printhead in an easycoder pd4/pd41/pd42 printer. The kit contains the following: • 200 dpi or 300 dpi thermal printhead • printhead adapter prin...
Page 2
To install the thermal printhead 1 turn off the printer and unplug the power cord. 2 open the side door of the printer. 3 raise the printhead by pulling out the printhead lever and turning it counterclockwise a quarter of a turn. 4 remove any thermal transfer ribbon. 5 remove the old printhead by pu...
Page 3
6 move the balance boxes to the center position, to facilitate the removal of the adapter pcb. 7 use an appropriate tool, for example a slotted screwdriver, to carefully pry the printhead cable connector loose from the adapter pcb. 8 remove the two screws that attach the adapter pcb to the printer. ...
Page 4
Worldwide headquarters 6001 36th avenue west everett, washington 98203 u.S.A. Tel 425.348.2600 fax 425.355.9551 www.Intermec.Com © 2007 intermec technologies corporation. All rights reserved. 13 close the side door of the printer. 14 plug in the power cord and turn the printer on. Easycoder pd4/pd41...