Installation instructions easycoder pd4 cutter.
Ii easycoder pd4 cutter installation instructions intermec technologies corporation corporate headquarters 6001 36th ave. W. Everett, wa 98203 u.S.A. Www.Intermec.Com th e information contained herein is proprietary and is provided solely for the purpose of allowing customers to operate and service ...
Easycoder pd4 cutter installation instructions iii contents contents before you begin ........................................................................... Iv safety summary .............................................................. Iv global services and support .............................
Iv easycoder pd4 cutter installation instructions before you begin before you begin th is section provides you with safety information, technical support informa- tion, and sources for additional product information. Safety summary your safety is extremely important. Read and follow all warnings and...
Easycoder pd4 cutter installation instructions v before you begin global services and support warranty information to understand the warranty for your intermec product, visit the intermec web site at http://www.Intermec.Com and click service & support. Th e intermec global sales & service page appea...
Vi easycoder pd4 cutter installation instructions before you begin.
Easycoder pd4 cutter installation instructions 1 1 installation th is chapter describes how to install the easycoder pd4 cutter..
2 easycoder pd4 cutter installation instructions chapter 1 — installation installing the cutter 1 unpack your easycoder pd4 cutter kit and check to see that all parts are included. If not, contact your sales representative. Front cover screw 2 make sure the printer is unplugged. Remove the screw tha...
Easycoder pd4 cutter installation instructions 3 chapter 1 — installation tear bar screws 3 open the side door and remove the tear bar, which is held by two phillips screws. 4 attach the cutter mechanism to the printer using the two phillips screws and washers included in the kit..
4 easycoder pd4 cutter installation instructions chapter 1 — installation cable clips cutter cable cutter connector 5 plug in the cable from the cutter into the rear one of the two connectors in the center section and fasten the cable to the bottom plate using the two cable clips included in the kit...
Easycoder pd4 cutter installation instructions 5 chapter 1 — installation 7 install the media as described in the loading media chapter, section “tear-off (straight-through)” of the easycoder pd4 user's guide. Rec- ommended label/paper length is at least 30 mm (1.18 in). Note: make sure that the prin...
Intermec technologies corporation corporate headquarters 6001 36th avenue west everett, wa 98203 u.S.A. Tel 425.348.2600 fax 425.355.9551 www.Intermec.Com *1-960646-00* easycoder pd4 cutter installation instructions *1-960646-00*.
