Jablotron 100 User Manual - page 10
9
DURESS ACCESS CONTROL
Provides unsetting of the system in a special mode. The system seemingly unsets, however it triggers
a silent panic alarm, which is reported to selected users (including ARC).
Unsetting under duress is executed by adding 1 to the last number in a valid code. Contact your service
technician if you want to use this feature.
Example for a code with the prefi x:
Valid code: 2*9999
Code for unsetting under duress: 2*9990
Example for a code without the prefi x:
Valid code: 9999
Code for unsetting under duress: 9990
2.1.3 PARTIAL ALARM SETTING
The system can also be confi gured to be partially set which allows guarding only by certain detectors
in a section. Example: At night, it’s possible to set the door and window detectors only, while motion
detectors inside a house do not react to anything.
To set the entire premises in which partial setting is enabled, the button to set the system has to be pressed
twice. After the button is pressed once it fl ashes yellow, after it is pressed a second time it fl ashes red.
If the system is partially set already – showing a continuous yellow light – the entire system can be fully
set by authorization and pressing the yellow button. Once the button is pressed, the system will be fully set
and the button turns red.
Partial setting can be confi gured in a way that authorization is not required.
2.1.4 TERMINATING A TRIGGERED ALARM
1. Authorize yourself using the keypad
(enter a code or hold a card or tag up to
the reader). The green backlit indication
button will start fl ashing.
2. Press the right segment button of the
selected section.
3. The command is executed and the
segment button turns permanently yellow
to indicate a partially set section.
1. Authorize yourself using
the keypad (enter a code,
hold a tag up to the reader).
2. Press the left segment
button of the section in which
the alarm has been triggered.
3. Unsetting is fi nished and
sirens are silenced. The green
fl ashing button indicates unse-
tting of the particular section.
The red fl ashing light indicates
alarm memory.
4. Authorize yourself and
press the green button again
to cancel the alarm memory
indication.
5. The segment indicates the
unset section with a continu-
ously lit up green button.
2. OPERATING THE JABLOTRON 100 SYSTEM