Jablotron 100 User Manual - page 16
15
Only the system administrator or service technician can block a user. One method of taking away access
rights is by choosing Settings / Users / User / Bypass and selecting “Yes” on the LCD keypad. Another
option is to locally or remotely block a user through the J-Link software by clicking on the user
in the Settings / Users / User blocking column.
A blocked (disabled) user will be marked with a red circle until the blocking is cancelled.
3.2 BLOCKING DETECTORS
A detector can be temporarily blocked in a similar way a user can be disabled. A detector is blocked
when its activation is temporarily not desirable (for example a motion detector in a room with a pet
or disable a siren sounding). The system still performs diagnostics of tamper contacts and sends service
events however the alarm function is deactivated.
Only the system administrator or service technician can block a detector. It can be achieved by choosing
Settings / Devices / Bypass and selecting Yes on the LCD keypad. Another option is to use the J-Link
software by clicking on the detector in the Settings / Diagnostics / Disabled column. A blocked detector
is marked with a yellow circle until it is turned back on using the same procedure. A device can be also
blocked from MyJablotron service and MyJABLOTRON smartphone app.
3.3 DISABLING TIMERS
To temporarily disable automated scheduled events in the system, a timer can be disabled. Disabling
a scheduled event (e.g. unsetting the system from night guarding at a predetermined time) will prevent
execution of that event (e.g. while on vacation).
A timer can be disabled locally or remotely through the J-Link program by clicking on the section
in the Settings / Calendar / Blocked column. A disabled timer is marked with a red circle until it is turned
back on using the same procedure.
4.1 CHANGING USER ACCESS CODE
If the system is set up with prefix codes, individual users can be allowed to change their codes
from the LCD menu on the keypad. The code can be changed after authorization by selecting Settings
/ Users /User / Code. To input a new code you must enter edit mode (the code will start to flash) by
pressing Enter, enter the new code and confirm by pressing Enter again. After completing the changes
they must be confirmed by choosing Save when the system prompts you with “Save Settings?”
If the system is set up without prefixed codes, only the system administrator and the service
technician can change the security codes. The system administrator can make changes from both
the LCD keypad menu the J-Link software and MyJABLOTRON smartphone app.
4.2 CHANGING, DELETING OR ADDING AN RFID CARD/TAG
If the system is set up with prefi xed codes, users can add, change or delete their RFID tags or cards
from the LCD menu on the keypad. These changes are done after authorization by selecting Settings /
Users / User / Access card 1 (or 2). To enter a new RFID card/tag, you must enter edit mode (access card 1
or 2 will start to fl ash) by pressing Enter. Then The RFID card/tag must be placed on to the reader or
the serial number must be manually entered. After confi rming by pressing Enter again, the RFID card/tag
is added. To delete an access card enter “0” into the serial number fi eld. After the changes are complete
the change must be saved by selecting Save when the system prompts with “Save Settings?”.
3. BLOCKING/ DISABLING THE SYSTEM
4. CUSTOMIZING THE SYSTEM