K9Safety K9Caller Operator's Manual - page 6
The antenna shows status of the alarm functions
and is used to enter programming features, valet
override and emergency disarm.
If your remote is lost or not functioning and your
alarm is armed, you can enter the vehicle, the
alarm will sound, and the auto engine run will shut
down if already running, turn on the ignition key,
and hold the antenna button for approx 10 sec-
onds.
There are three user controls that operate the various features of the system.
Some features can be control by more than one devices. The user control devices are the
control switch, the remote control (2-way & 1-way) and the antenna.
The control switch allows the user to activate and deactivate the
k9system, trigger the alert delay, and display k9system status.
The 2-way remote allows the user to activate and
deactivate the k9system, receive alert signals check
temperature, arm/disarm the alarm system, set tem-
perature thresholds, and remote start the vehicle to
name a few. Please see the page 5 for more detail.
User Controls Described
Page 6
Two Way Antenna Button and LED
Status LED
Activation &
Alert Delay Switch
Alarm Status
LED
Program
Button
Valet mode should be used whenever the vehicle is sent for maintenance or repair as it
will prevent the auto start, door pop, and alarm from functioning. After service, remember
to take the system out of Valet Mode. To put the system in or out of Valet, Turn on the
ignition and press and hold the antenna button for 5 seconds. The control switch LED will
flash while in valet. Repeat the process to take the system out of Valet mode.
System Valet Mode: