K9Safety K9Caller Operator's Manual - page 8
Pressing and holding button # 5 will scroll through the six available options at approximately
1 per second. To access you must hold button # 5 until the desired parameter is displayed
then release button # 5
It is recommended that you check con before changing any of the parameters using button 5.
This will insure that you are in range and that the system is not
“busy”
CON : reports ECU conditions; auto start running/off, security system on/off.
To display system status:
1. Press and hold Button 5 until the display shows CON.
· The transmitter will beep once.
2. Release Button 5.
· The transmitter will beep once.
· The LCD panel will display the current system status.
deg : reports the cabin temperature.
1. Press and hold Button 5 until the display shows DEG
·The transmitter will beep twice.
2. Release Button 5.
· The transmitter will beep four times.
· The LCD panel will display the temperature inside the vehicle
CHP : Turns on/off the siren chirp. This feature has no effect as no siren is installed. The
vehicle horn is used as an audible alert.
1. Press and hold Button 5 until the display shows CHP.
·The transmitter will beep three times.
2. Release Button 5.
· The transmitter will beep once.
· The LCD panel will show a siren if the chirps*/honks are enabled or "off" if the chirps*/
honks are disabled.
SND : Selects between audible sound or vibrate on the Keychain Remote.
Set the transmitter confirmation tones ON or OFF:
1. Press and hold Button 5 until the display shows SND.
· The transmitter will beep four times.
2. Release Button 5.
· The transmitter will beep once.
· The LCD transmitter will beep 5 times and display “on” if the sounds are enabled or vibrate
and display "off" for the Remote to vibrate.
PSU : Selects between the K9 functions activating manually or passively arm after arrival.
1. Press and hold Button 5 until the display shows PSV.
· The transmitter will beep five times.
2. Release Button 5.
· The transmitter will beep once.
· The LCD panel will play a tone and display “on” if enabled or "off" if disabled.
*Note this function is not available when remote lockout is selected.
Remote Button 5 Menu
Page 8