K9Safety K9Caller Operator's Manual - page 7
The K9 features can be activated and deactivated by pressing and holding the control switch
button for 2 seconds while the ignition is on. This will toggle activation/deactivation each
time. While activated the K9 features such as hot temperature alert, hot temperature start, and
door pop are ready to be triggered and the blue L.E.D. on the control switch will light steady.
While deactivated the K9 features will be turned off and the L.E.D. will not be lit. The control
switch will also trigger the alert delay if the system has triggered the hot temperature alert
(horn honk, window down, etc) which will delay the alert from triggering for 5-10 minutes
depending on programming.
The Keychain remote is used to receive high temperature alert notification, turn On/Off the
security system tied to all four doors, remote check vehicle cabin temperature, or remotely
auto start the vehicle (Alert receive range is up to 1500ft and keychain transmit range is
up to 1000ft depending on environment).
There are five buttons and several icons on the keychain remote which perform certain func-
tions on the system or indicate system status.
Button #1 is used to turn On the vehicle security system which is connected to all entry doors.
Button #2 is used to turn Off the vehicle security system.
Button #3 is used for door pop or trunk pop.
Button #4 is used to remotely auto start the vehicle.
Button #5 is used to check the last signal including, security armed/disarmed, engine auto
start active, and cabin temperature.
This button can also be used to change the ECU state in/out of valet which will affect the
normal operation of the security system. It will not affect the system
’s ability to normally
operate the temperature auto start or temperature alert. Pressing and holding button # 5 will
scroll through the options at approximately 1 per second. To access you must hold button # 5
until the desired parameter is displayed then release button # 5
Note the following features are not accessible in remote lockout mode and no changes
can be made via the remote.
PSV, VAL, Setting the Call Temperature, Setting the Hot Start Temperature
Keychain Remote
Page 7