Kampmann KaCool D 1 Installation And Operating Instructions Manual - Faults
KaCool D
02.02.2017
58
Faults
Fault display
9
Faults
The following chapter describes possible causes of faults and
the work to rectify them. Reduce the maintenance intervals
according to the actual load in case of increasingly occurring
faults. Contact the manufacturer in case of faults that cannot
be rectifi ed using the following information ( Chapter 1.4
"Customer Service" on page 6).
Behaviour in case of faults
As a basic rule:
1.
Switch off the unit immediately in case of faults that
represent an immediate danger to persons or property.
2.
Determine the cause of the fault.
3.
If rectifying the fault requires working in a danger zone,
switch off the unit and prevent it from being switched
on again. Immediately inform the person in charge at the
operating site about the fault.
4.
Arrange for the fault to be rectifi ed by authorised
specialist personnel or rectify it yourself depending on
the type of fault.
9.1 Fault Display
The KaControl operating unit displays fault messages. Firstly,
observe the separate operating unit instructions.
The fault table ( Chapter 9.2 "Fault Tables" on
page 59) provides information on who is entitled to
rectify faults.
Fig. 70: KaControl operating unit
Master unit
EC 1