KanexPro HDSC51HDBT User Manual - page 14
Compact Scaler Switcher (with PoE)
10
The display result will be showed for 2 seconds
The auto-switching mode follows the following principles:
Ø
New input principle
Once a new input signal is detected, the compact scaler switcher will switch to this
new signal automatically.
Ø
Power rebooting principle
The scaler switcher offers the function to remember the signal last used after
rebooting. Once rebooted, it will automatically enter auto-switching mode, and then
detect all inputs and memorize their connection status for future reboots. If the last
used input signal is still available, then it will choose that signal. If not, there will be
no output.
Ø
Signal removing principle
Once the current signal is removed, the compact scaler switcher will detect all input
signals with priority on INPUT 1 to INPUT 5. It will transfer the first signal detected to
the outputs.
Notice: Auto-switching function works only when there is a new input signal or if an
input signal is removed. With any VGA port set to AV or YPbPr, the system will be not
able to enter Auto-switching mode.
Operation Examples
:
l
Connect the INPUT 2, INPUT 4, and INPUT 5 ports to the source devices, select
INPUT 4 to outputs.
l
Press and hold on the front key SOURCE/AUTO for 7 seconds or more to enter
auto-switching mode.
l
If there is no signal removed or no new input, the compact scaler switcher just works
in auto-switching mode. Take no action (Output from INPUT 4)
l
Connect INPUT 3 with a source device, and then it will choose INPUT 3 to output.
l
Remove the signal of INPUT 3, the compact scaler switcher will detect from INPUT 1
to INPUT 5. And when it detects that input 2 is available, it will choose INPUT 2 to
output.
l
Cut off the power of the compact scaler switcher, then reboot. As the compact scaler
switcher is in auto-switching mode, and then it will choose INPUT 2 to output.
IN: HDMI1 MANUAL
1280 X 720
IN: HDMI1 AUTO
1280 X 720
Auto-switching function