Kanrich 915 User Manual - page 15
SPK.
Mic.
VR2
VR3
1 2 3 4 5 6
In
/O
u
t
+
F
G
N
D
一
G
N
D
(i
n
te
rc
o
m
)
B
e
ll e
x
te
rn
a
l b
e
ll s
w
it
c
h
switch
u
s
e
le
s
s
E
X
S
P
K
e
x
te
rn
a
l S
P
K
.
Connect to monitor to monitor
when one apartment(or house)
has 2 monitors(or handsfree audio).
1 2 3 4 5 6
S1
S1 - Dummy Load
ON
OFF
Terminals
VR2
Calling Tone Adj.
VR3
External SPK. Volume Adj.
- +
- +
915Mg Audio Handset
Power
Indicator
Code setting button/Main monitor & Sub monitor setting button
Code setting button
: When doorphone system is standby and press
" + ", you will hear "Du" on 915Mg and on camera ,too.
Please enter "915Mg code"on camera immediately , 915Mg will get this call
and send "Ding-Dong" , it means a successful code setting .
: Hold “ “ 8 sec. at least ,you will
Main monitor-Sub monitor setting button
hear a high-pitch “Du", it means to set main monitor successfully.
Then, hold this button 8 sec. at least , you will hear a deep "Du" , it means to
set sub monitor successfully.
PS. One apartment only can set one main monitor, if you set 2 main monitors
in one apartment , camera can't call monitor normally ,the doorphone system
will happen problem ,camera can't make a call to this apartment .
Intercom Button/ NO Contact Point
Intercom
Press this button to intercom and talk with other monitors in
this apartment .
When monitor screen is started , press this button and
NO Contact Point
drive this contact point in camera then to start other devices.
Door Release Button /
Code setting button
Door Release
Press " " this button for opening door.
: When doorphone system is standby and press
Code setting button
" + ", you will hear "Du" on 915M35 and on camera ,too.
Please enter "monitor code"on camera immediately , 915M35 will get this call
and send "Ding-Dong" , it means a successful code setting .
Handsfree Talking Button
:
it
Handsfree Talking button
Press for getting a call and talking .
After talking press it again for finish.
Door Status Indicator
: The red LED constantly lights on , it means the door is open, the red LED lights off ,
it means the door is close .
“In Use"indicator / Intercom call Indicator(Red):
The red LED constantly on, it means one of residents is using this doorphone system,please wait this resident
finishing talking then to use it .
This indicator is flashing , it means intercom function is started.
Intercom Indicator :
Specifications
Working Voltage: DC15V from 915P
Current Consumption :
Stand-by 40mA, Working 150mA
Communicating Interface:
the modulated carrier wave signal
Installation way: Surface mounting type
Material: ABS
heat-resistant plastic
Dimensions: (H)210mm/(W)94mm/(D)40mm
Weights : 300gs
Measurement: 0.08 cuft
Rear
View
P25
2011 Sep.