Kanrich 915 User Manual - page 7
Accessories
1. 7-pin connector 1
2. Bracket 1
3. Screw bag 1
REAR
VIEW
In
/O
u
t s
y
s
te
m l
in
e
+
F
G
N
D s
y
s
te
m l
in
e
一
E
x
te
rn
a
l S
P
K
G
N
D
V
id
e
o O
u
t
B
e
ll
G
N
D
Monitor
E
x
te
rn
a
l b
e
ll s
w
it
c
h
To connect all monitors
in the same house.
915M35 3.5” Handsfree Color Monitor
Handsfree Talking / Monitoring Button
:
it
Handsfree Talking button
Press for getting a call and talking .
After talking press it again for finish.
Monitoring button
:
it
Press to start monitor screen and monitor door camera
situation and also to talk with camera ,press
for finish.
it again
The talking time limitation is 180 sec.
.
“In Use" indicator / Intercom call Indicator(Red):
The red LED constantly on, it means one of residents is using this doorphone system,
please wait this resident finishing talking then to use it .
This indicator is flashing , it means intercom function is started.
Intercom Indicator :
Power Indicator
: The Blue LED constantly lights on.
SPK.
Mic.
C
o
lo
r
Code setting button/Main monitor & Sub monitor setting button
Code setting button
: When doorphone system is standby and press
" + ", you will hear "Du" on 915M35 and on camera ,too.
Please enter "monitor code"on camera immediately , 915M35 will get this call
and send "Ding-Dong" , it means a successful code setting .
: Hold this button 8 sec. at least ,
Main monitor-Sub monitor setting button
you will hear a high-pitch “Du", it means to set main monitor successfully.
Then, hold this button 8 sec. at least , you will hear a deep "Du" , it means to
set sub monitor successfully.
PS. One apartment only can set one main monitor, if you set 2 main monitors
in one apartment , camera can't call monitor normally ,the doorphone system
will happen problem ,camera can't make a call to this apartment .
Intercom Button/ NO Contact Point
Intercom
Press this button to intercom and talk with other monitors in
this apartment .
When monitor screen is started , press this button and
NO Contact Point
drive this contact point in camera then to start other devices.
Door Release Button /
Code setting button
Door Release
Press " " this button for opening door.
: When doorphone system is standby and press
Code setting button
" + ", you will hear "Du" on 915M35 and on camera ,too.
Please enter "monitor code"on camera immediately , 915M35 will get this call
and send "Ding-Dong" , it means a successful code setting .
B
ri
g
h
tn
e
s
s
C
a
lli
n
g T
o
n
e A
d
j.
Door Status Indicator
: The red LED constantly lights on , it means the door is open, the red LED
lights off , it means the door is close .
Specifications :
Working Voltage :
DC 15V from 915P
Current Consumption:
Standby 40mA
Working 300mA
Resolution: color 3.5”
320(H) x 240(V)
Communication Interface :
the modulated carrier wave signal
Installation Way : Surface Mounting Type
Front Material : ABS
Dimensions : 189.5(H)/129.5(W)/30(H)
mm
Weights:
310 gs
Measurement:
0.3 cuft
P15
2011 Sep.
Dummy Load
ON ↑
OFF↓
1 2
N0.1 No Function