Keba KeContact P20 Installation Manual - page 23
Installation
23 / 48
Schematic diagram
Mounting the charging station
►
Turn the hanger bolts into the anchors
until the thread still protrudes
approx. 2 cm (
'x'
).
►
Use the shims
[A]
to compensate for any
unevenness and to ensure a water
drainage behind the device.
►
Position and mount the charging station
using the supplied washers and nuts.
[A]
…shim
[B]
…charging station housing
[C]
…washer
[D]
…nut
Installation on hollow walls
Installation on hollow walls
For installation on hollow walls, at least two
mounting screws must be secured to a support
element of the wall (see figure).
Special hollow-wall anchors must be used for
the other mounting screws.
When installing on hollow walls you must en-
sure that the bearing strength of the construc-
tion is sufficient.