Keba KeContact P20 Installation Manual - page 32
Other manuals for KeContact P20:
Installation Manual, User Manual
of
48
Installation
32 / 48
LSA+® insertion tool
LSA+® insertion tool
Original KRONE insertion tool with solder-free
and stripping-free connection of the wires and
simultaneous trimming of the residual lengths.
Preparing the connection cable
Preparing the connection cable
►
Strip the connection cable approximately
6 cm.
►
Fold back approx. 1 cm of shielded
braiding completely and wrap it with
conductive adhesive textile tape.
Connecting the cable
Connecting the cable
►
Secure the connection cable at the point
of the wrapped shielded braiding in the
cable clamp
[K]
.
The cable clamp must be screwed onto
the ground point
[GND]
of the circuit
board.
►
Clamp the wires to the terminal block
[ETH]
using the insertion tool.