Keba KeContact P20 Installation Manual - page 6
Important information
6 / 48
!
WARNING!
Pull the charging cable only at the plug and not at the cable out of the con-
nector.
Ensure that the charging cable is not mechanically damaged (bent, pinched or
run over) and the connection area does not come into contact with heat
sources, dirt or water.
5 safety rules:
- Shut down all poles and all sides!
- Secure against reactivation!
- Check that the equipment is voltage-free!
- Ground and short-circuit!
- Cover adjacent live parts and restrict access to hazardous areas!
ATTENTION
Risk of damage!
Make sure that the charging station is not damaged by improper handling (an-
choring, housing cover, socket, inner parts etc.).
Do not open the connector panel cover in the rain!
Risk of breaking the plastic housing!
- Countersunk screws may not be used for the mounting!
- The included washers must be used.
- Do not tighten the mounting screws with force.
- The mounting surface must be completely level (max. 1 mm difference be-
tween the support points or mounting points). Warpage of the housing must be
prevented.
Information for technicians who are permitted to open the device:
Risk of damage!
Electronic components can be destroyed if touched!
Before handling components, make sure you perform an electrical discharge
by touching a metallic, grounded object!