Kedacom IPC411 User Manual - page 11
High Speed Dome Camera
User Manual
7
7
Picture 3-2 Snapshot Configuration
3.1.2
Image Adjustment
3.1.2.1
Focus
3.1.2.2
Zoom
3.1.2.3
Brightness
User can set or modify save path for PU Snapshot and Local Snapshot in Parameter>Local Setting,
as shown in Picture 3-2.
Recording
/
Click this button to start recording and click again to stop recording. Recording is saved on local PC.
User can set or modify save path in Parameter>Local Setting.
Focus is to make image clear.
On the top of function buttons, click
or
(manual). When select manual focus,
(near) and
(far) will pop up.
When PTZ control stops and auto focus is unnecessary, open Parameter>PTZ Function>Guard
Tour, and enableAuto Focus Stopped and set time (e.g. 10s), then lens will stop auto focus after
PTZ stops for this time duration (10s).
Zoom in or zoom out to suit different scenes.
Click
to zoom out and
to zoom in.
Note: In different scenes, the default angular speed of PTZ is the same. Enable Auto PT Speed to
set same linear speed of PTZ in different scenes.
Auto PT Speed can be set on Page 2 of function buttons. Check the checkbox to enable this function.
Due to low light situation, the image will look completely or partially dark and hard to recognize.
IPCCtrl provides the following functions to increase image brightness and ensure surveillance
quality.
Increase Image Brightness
In Image Adjustment part, user can drag Brightness slide bar to adjust image brightness.
Increase Lens Aperture
Aperture controls light input in lens. The larger the aperture is, the more light there will be and
the brighter the image will be.
Slower Shutter Speed
Camera shutter speed means the cycle of the sensor calculating light input amount. Therefore,
the slower the speed is, the brighter the image is.