Kedacom IPC411 User Manual - page 14
High Speed Dome Camera
User Manual
10
10
3.1.3.2 Auto Patrol
Auto Patrol function can realize shift between different positions. These positions are called Preset Positions, which
shall be preset be user.
Configure Preset Position
Adjust PTZ and field of view to ideal position, set preset position number
on Page 1 of function buttons
and click
(Set) to save current preset position. Click
(Remove) to remove preset position and reset.
Also, user can set preset position through Parameter interface. Open Parameter>PTZ Function>Preset Settings, set
Preset No., modify Preset Name and click
. Click
to cancel preset position and reset. Click
to load preset position.
Load Preset Position
On Page 1 of function buttons, click
(Load Preset Position) and PTZ will rotate to the preset position
immediately.
When power on, camera will rotate to mechanical zero by default. Set preset position, and enable function of Power
on to Load Preset Position, then camera will load preset position automatically after power on.
Open Parameter>PTZ Function>Guard Tour, enable Power Loss Recovery, select Power on to Load Preset Position
and input the preset position number.
Picture 3-5 PTZ Function>Guard Tour
Power Loss Recovery: Select Power Loss Recovery from the drop-down list. When PTZ stays at the same position
for a certain preset time, camera will remember the position and load this position automatically when the camera is
rebooted. Default preset time is 30 seconds.
Picture 3-6 PTZ Function>Guard Tour>Power Loss Recovery
Preset Position Patrol: After set multiple preset positions, click
(Start) on Page 1 of function buttons, and
camera will patrol among random 8 preset positions. Click
(Stop) to disable preset position patrol.
Also, user can set Preset Position Patrol in Parameter. Open Parameter>PTZ Function>Preset Position Setting: