Kedacom IPC411 User Manual - page 17
High Speed Dome Camera
User Manual
13
13
Reset: Click
(Reset) to make PTZ return to the original position and maximize the view field. Reset is in the
center of PTZ control keys.
Pan Zero Correction:Reset PTZ to the mechanical zero. On Page 3 of function buttons, click
(Pan Zero
Correction).
3.1.3.6 Variety Patrol
Variety Patrol means camera patrols according to the PTZ movement trails in a recorded duration.
On Page 7 of function buttons, set Variety Patrol Paths, and 4 paths can be configured.
Start Rec.: Select a Variety Path, click
, operate PTZ control of
, and record PTZ
rotation, step and zoom. Click
to stop recording. Each path can be maximum 10 minutes. Click
to view all operations.
Remove Rec.: Select a Variety Path, and click
to remove all recorded PTZ operations on this path.
3.2 Alarm Linkage
Alarm Linkage settings: Intelligent Alarm, Parallel Port Alarm connecting to alarm output device.
3.2.1
Intelligent Alarm
Detect movements in the defined area. Once the movement exceeds the defined sensitivity, an alarm will be
triggered. Alarm Recovery Time can be set 0~300s, and default is 5s.
Set Area: Check Parameter>Video Parameter>Intelligent Alarm to check Enable Intelligent Alarm. Select
Motion Detection from the drop-down list, and set detection area.Click a square and it will turn purple red. Start
from this square and draw an area to be the detection area,which will turn purple red. Camera can be set 4
areas of Motion Detection.
Clear Area: Start from an undefined square and draw an area that contains the defined area, or click the
defined squares one by one to clear setting. Save to make settings effective.
Disable Function: To disable this function, uncheck the checkbox
Enable Intelligent Alarm.
3.2.2
Parallel Port Alarm
OpenParameter>Parallel Port Alarm. Parameters are as follows:
Parameter
Explanation
Alarm Name
Alarm input device name, such as Front Door
Smoke Detector
Alarm Input Type
Always Open or Always Close for option
Linked Camera
Support
Alarm Output
Select output devices such as alarm bell or
spray.
Select “No Output” and no alarm linkage will
be triggered except Alarm Text.
Alarm Scheme
Select alarm detection and duration.
Select “No Detection” and effect will be the
same as above, neither will alarm text
overlaid.
When select “Specific Duration”, set alarm
detection duration.
3.3 Privacy Mask
Mask sensitive and private part of the image so as to keep sensitive information private.
3.3.1 Set Area
1) Check Parameter>Video Parameter>Privacy Mask to set privacy mask area.
2) Check Enable Privacy Mask.
3) Click a square and it will turn purple red. Start from this square and draw an area to be the masking
area, which will turn purple red.
.
The image is divided into 16 columns and 12 rows of small squares. The maximum masking area
can be 24 squares. The maximum number of Privacy Mask area is 4.