Keiser M3I Installation And Operation Manual - page 12
p12.
M3i INDOOR GROUP CYCLE
ASSEMBLING THE DEVICE HOLDER
Figure 19. Assemble the device holder to the
handlebar
Figure 20. The assembled handlebar and
device holder
To install the device holder, apply force in the direction shown in Figure 19. The device holder will fit to the handlebars as
shown in Figure 20.
FINAL INSTALLATION AND CHECKING FOR PROPER OPERATION
• Are all parts correctly installed?
• Are the four Acorn nuts that secure the main cycle frame
to the base frame torqued at 45 Nm (35 ft-lbs)?
• Are pedals installed with thread locking compound and
torqued to 45 Nm (35 ft-lbs)?
• Are all screws and nuts properly torqued and tightened?
• Do the handlebar and seat adjustments operate
properly?
• Was LPS #3 applied to the left bottom bracket bearing?
• Was LPS #3 applied to the clip-in portion of the pedals?
• Is the computer installed and operational?
• Polish the cycle with paste or spray wax and a clean
cloth?
• If all assembly requirements have been met, test ride
the cycle.
NOTE: Perform the operations below before riding the cycle. Failing to test a cycle prior to normal use will void your
warranty and could result in serious injury.
APPLY THE HOLE COVER DECALS
Figure 21. Hole Cover Decal Placement
Install the hub cover decals as shown in figure 21.
The decals should completely cover each of the 5
holes on the flywheel hubcap.