Keiser M3I Installation And Operation Manual - page 22
p22.
M3i INDOOR GROUP CYCLE
WARNING: Do not burn batteries. Do not place batteries in waste bins. Batteries must be disposed of
by a Licensed Waste Collector. Battery leakage is extremely caustic and contact with bare skin should
be avoided. In the event that battery leakage comes in contact with your skin, flush the area for 15
minutes with copious amounts of water and seek medical attention. Gloves, overalls, safety shoes and
eye protectors must be used when handling leaking batteries. Follow manufacturer’s recommendations
when handling and maintaining batteries.
COMPUTER BATTERY REPLACEMENT
M SERIES CARDIO CALIBRATION
If the battery is low the Odometer (ODO) setting will display “LO-BA”.
To replace the batteries:
1. Remove the screw from the back of the computer housing.
2. Remove the two old AA batteries. Be sure to dispose of the batteries with a licensed waste
collector.
3. Install two new AA batteries with the correct orientation as shown inside the battery housing.
Replace the batteries with AA, R6 or LR6 type batteries only. Do not use FR6 or similar type
batteries.
4. Replace the back to the computer housing and tighten the screw.
All M Series equipment is calibrated with a tool at the factory and there is no need to calibrate, unless a component
associated with the resistance mechanism or computer require service.
Figure 35. Battery
Compartment
COMPLIANCE
This device complies with Industry Canada licence-exempt
RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
Le present appareil est conforme aux CNR d’Industrie
Canada applicables aux appareils radio exempts de
licence. L’exploitation est autorisee aux deux conditions
suivantes : (1) l’appareil ne doit pas produire de brouillage,
et (2) l’utilisateur de l’appareil doit accepter tout brouillage
radioelectrique subi, meme si le brouillage est susceptible
d’en compromettre le fonctionnement.
REGULATORY NOTICE
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and
receiver.
— Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician
for help.
- Changes or modifications not expressly approved by Keiser Corporation could void the user’s authority to operate the equipment.
- Upon end of life of this cycle, be sure to remove the batteries and scrap the machine according to your local laws and
regulations.
REGULATORY AND COMPLIANCE NOTICES
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks
by KEISER is under license. Other trademarks and trade names are those of their respective owners.