Kuschall Compact Service Manual - Service Manual
15
© Küschall AG, Schweiz | 2011-07
Service Manual
Backrest
Fitting height adjustable, rear set push handles
Difficulty:
Tool:
Ò
Ã
3, 4, 5
8, 10
The Velcro® bands may have to be replaced with narrower ones, as space is
required to secure the holder on the telescopic tube.
Secure the telescopic tube to the rear frame at the required
height.
Press the cover cap onto the end of the telescopic tube.
Push the Velcro® bands onto the telescopic tube.
Push the holder onto the telescopic tube and fix in place by
tightening the clamp bolts (13 Nm).
Fit end band onto the telescopic tube and secure with a bolt.
Attach protective cushion.
Fitting angle-adjustable backrest with height-adjustable push
handles
Difficulty:
Tool:
Ò
Ã
3, 4, 5
8, 10
10
Shorter rear frame (variant III) required.
Push the lower joint pin into the rear frame and fix it using the
bolts.
Fit backrest tube onto the upper joint pin using bolts. Assemble
the upper and lower joint pins and and secure with a bolt .
Set the desired backrest angle and secure in the nearest hole using a
nut and bolt .
Retighten the bolt
.
Push the single Velcro® band and then the other Velcro® bands
and end band over the backrest tube .
Push in push handle completely.
Using the clamp bolt
a
fit the height-adjustable push handles
through the telescopic tube .
Fit end band onto the telescopic tube with a bolt.
1
3
2
5
6
4
1
2
3
4
5
6
9
10
8
7
11
à 13 Nm
à 13 Nm