Kuschall Compact Service Manual - Service Manual
32
© Küschall AG, Schweiz | 2011-07
Service Manual
Options & accessories
Options & accessories
Antitipper
Fitting an antitipper
Difficulty:
Tool:
Ã
5
10
Secure adaptation support with bolt onto the adapter plate .
Height adjustment
Difficulty:
Tool:
Ã
4
8
1
Loosen bolt and remove the upper end of the antitipper and the
holder. Remove the sealing cap (e.g. push it out through the tube
using the screwdriver).
2
Loosen bolt of the antitipper tube and push sleeve into the
correct position.
3
Screw bolt in half way, position spring in sleeve and screw bolt
completely into the tube.
4
Put all the parts of the antitipper back together; in doing so pull
spring apart, e.g. using a wire hook, and secure it with the top bolt
.
Set the antitipper parallel to the wheel chair and tighten the bolts.
Function check:
The distance between the antitipper and the ground must be 40 - 60 mm.
It must be easy to fold up the antitipper.
Tip the wheelchair backwards using the antitipper until the axle is perpen-
dicular to the antitipper’s point of contact with the ground. In this position,
the distance between the rear wheel and the ground must be at least
50 mm.
2
3
1
1
3
4
2
5
2
7
6
1
3
8
5
7
6
x
x 50 mm
à 13 Nm
à 4 Nm
à 7 Nm