Lampo HYPERCOLOR 575 User Manual - page 10
9
MAINTENANCE
CAUTION
Safety guards, lenses, and filters must be replaced if they are visibly damaged to the point that they become
ineffective (for example, if they have deep slashes or cuts).
The lamp must be replaced if damaged, cracked, or deformed by the heat.
PLANNED MAINTENANCE
at user’s charge and responsibility
Operation Frequency
Action
Lamp replacement
750 hours
M1
Surface temperature test
Quarterly
M3
Cleaning Two
months
M4
Testing of safety breaker circuit on general
electric system
Monthly
Check life-saving safety device pressing “T” button
Check damage to cables due to mobile use
of projector
Once a year
Replace cables if
damaged
NOTE: To ensure the correct functioning of the unit, a general service check of the projector must be made, twice a
year, from an authorized technician
ATTENTION
Always use original spare parts to ensure safe and proper functioning of the projector.
ATTENTION
Do not make changes to the projector. A modified projector requires a new CE marking.
M1 - LAMP REPLACEMENT
The lamp must be replaced with the same type of lamp and according to the same frequency. A less efficient lamp
jeopardizes projector performance. Replace the lamp as follows:
- When the projector is cold, turn off the ON/OFF switch to cut the electricity and follow the instruction as explained
in page 3 of this manual .
-Switch on the projector to make sure the lamp is working correctly.
M3 - SURFACE TEMPERATURE TEST
Before you check the temperature, make sure the projector is in the full operating mode (wait about 20 minutes
after switching on the projector). Use a contact probe to measure the surface temperature on the projector’s metal
case and determine the hottest area (Top lid near to the lamp). The temperature must be less than 70°. Otherwise,
check the cooling system.
M4 - CLEANING
ATTENTION
Cleaning must be carried out when the projector is cool, disconnected from the power supply, with the general
power switch turned off, and the ON/OFF switch on the rear panel switched OFF.