Lampo HYPERCOLOR 575 User Manual - page 5
4
No more than three identical boxes can be stacked one on top of the other.
Keep the original packing for possible shipments in the future.
Storage
The projector, in its original packing, must be kept in covered, dry areas with a temperature between -10° C and
+50° C.
Handling
The projector, with or without packing, must be handled with care. Lifting and handling must be carried out with
special equipment. Do not expose the projector, with or without its packing, to brusque accelerated or decelerated
movements, knocks, dragging, or other stress caused by unsuitable handling methods.
IMPORTANT
The projector in its packing can be seriously damaged if it falls or suffers a blow during transportation.
HANDLE WITH CARE!
START-UP PROCEDURES
Positioning and Installation
Follow these steps for opening the package and installing the projector on its working position:
· Place the projector near the place it will be installed.
· Open the package and remove anchoring elements and accessories.
· Carefully read the instructions in the manual.
· Prepare suitable hooks for the anchoring brackets and auxiliary support.
· Using suitable lifting equipment, place the projector up against the hooks.
· Tighten the M12 bolts and insert a device to prevent them from accidentally loosening.
· Attach the auxiliary support element and make sure it is tightly fastened.
· Make sure all adjustable parts are locked firmly in place in the desired position.
CAUTION
You must verify the stability of the anchoring elements when the projector is in working condition. In compliance
with the laws in force, the anchoring support must withstand a load of 170 kg. Screws, hooks, and hardware must
be inserted correctly and installed to prevent them from accidentally loosening.
IMPORTANT
The projector was designed to function when attached to the bracket. The projector cannot function sitting upon a
flat surface that obstructs the rear cooling vents. Do not install the projector where there are objects located at a
distance of less than 20 centimetres from the cooling system.
Lamp installation
· Loosen the two knobs that close the top lid.
· Remove the lamp from the packing and carefully read the Manufacturer’s instructions.
· Position the new lamp into the socket without touching the glass with the hand or any other dirt or greasy thing.
· Reposition the top lid and firmly tighten the two knobs.
Admissible environmental Conditions
The projector was engineered and produced to function in covered, dry areas with an air temperature ranging
between 5° and 35°C, and with a humidity level between 30 and 90%. Sharp changes in room temperature may
generate condensation inside the projector, which can harm the projector. Therefore, switch on the projector only
after it has undergone a period of gradual adaptation to the room temperature.