Lampo HYPERCOLOR 575 User Manual - page 12
11
TROUBLESHOOTING
Problem Possible
cause
SOLUTIONS
Projector will not
turn ON
No mains power
No power to the
projector
Burned-out fuse
Make sure the mains power is ON and the circuit breaker hasn’t
been triggered
Make sure the switch on the back of the projector is ON.
Make sure the top lid is tightly closed
Replace the burned-out fuse *Use the type of fuse indicated on
the side of the fuse box
The lamp will not
light
Burned-out or faulty
lamp
Replace the lamp
The beam is not
regular
An optical element is
damaged
Dirt on glasses and
dichroic filters
Switch OFF the power and check the optical components. If
damaged call an authorized technician
Switch off the power and clean the parts as explained in the
cleaning paragraph
The projector does
not respond to
controller signals
Malfunctioning
signal cable
Wrong DMX address
Malfunctioning
electronic circuit
Malfunctioning motor
or transmission
Replace the cable and check the line before switching on again
the projector
Check the DMX SECTION dip-switch setting and correctly
reconfigure them
Contact an authorized technician
Discontinuous
projector functioning
Safety thermostat
has been triggered
Remove the dirt and check to see if the cooling system is working
properly
Contact an authorized technician
Noisy projector
Mechanical wear
Identify the source of the noise and remove the cause.
Contact an authorized technician
*Before switching on the projector, identify and remove the causes that made the fuse intervene
WARRANTY
HYPERCOLOR 575 is guaranteed against any manufacturing defects or material flaws, if defects or breakdowns
occur during the warranty period. After inspection and according to its own unquestionable judgment, the
Manufacturer will repair or replace the defective part.
The warranty is not valid in the following cases:
1. If the projector was used improperly or with negligence, or if it was damaged and repaired and/or modified to the
point of jeopardizing safe functioning.
2. If the projector is used in conditions other than those specified in this manual.
3. If non-original spare parts are used.
4. All malfunctioning and breakdowns caused by acts of God, negligence, and improper use, and parts subject to
wear are not covered by the warranty.
The Customer shall be responsible for all shipping costs for the material.
All orders for spare parts must be accompanied by the model of the projector and the serial number.