Landice Cardio Owner's Manual - Note:
ii
IMPORTANT SAFETY INSTRUCTIONS
[1]
This treadmill should never be left unattended when plugged in. Unplug from outlet when not in use.
[2]
Close supervision is necessary when this unit is used by or near children or disabled persons.
[3]
Use this treadmill only for its intended use as described in this manual.
[4] Never operate this treadmill if it has a damaged cord or plug, if it is not working properly, or if it has been
damaged. Call your selling dealer or certified service provider immediately for examination and repair.
[5]
Keep the power cord away from heated surfaces. Be sure the line cord has plenty of slack and does not get
pinched underneath the treadmill when it elevates and de-elevates.
[6]
Never operate the treadmill with the motor cover air openings blocked. Keep the air openings free of lint,
hair, and dust.
[7] Never drop or insert any object into any opening. Be sure no objects are near or underneath the moving
treadbelt when you are using the treadmill.
[8] Do not use outdoors.
[9] Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
[10] Connect this treadmill to a properly grounded, dedicated outlet only.
[11] When done using, press
STOP twice, remove the Safety Key, and unplug the unit from the wall outlet.
GROUNDING INSTRUCTIONS
This product must be grounded. If it should malfunction or break down, grounding provides a path of least resistance
for electric current to reduce risk of electric shock. This product is equipped with a power cord that has a grounding
conductor and a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded
in accordance with all local codes and ordinances.
120 VOLT TREADMILLS
Treadmills marked 120 VAC are intended for use in a nominal 120-volt circuit with a grounding plug. Make sure the product
is connected to an outlet having the same configuration as the plug. No adapter should be used with this product.
200 - 250 VOLT TREADMILLS
Treadmills marked 200-250 VAC are intended for use on a circuit having a nominal rating more than 120V and are
factory-equipped with a specific power cord and plug to permit connection to a proper electrical circuit. Make sure the
product is connected to an outlet having the same configuration as the plug. No adapter should be used with this product.
If the product must be reconnected for use on a different type of electrical circuit, qualified service personnel should make
the reconnection.
NOTE:
Using a Ground Fault Interrupter (GFI) or Arch Fault Circuit Interrupter (AFCI) outlet may create unusual
electronic interference.
DANGER:
Improper connection of the equipment-grounding connector can result in a risk of electric
shock. Check with a qualified electrician/serviceman if you are in doubt as to whether the product is properly
grounded. Do not modify the plug provided with the product. If it will not fit in the outlet, have a proper outlet
installed by a qualified electrician.
WARNING:
To reduce the risk of electric shock or injury to persons: