Lanier R/C MARINER 40 MK II ARF Instruction Manual - page 13

13

❏ 

4. Cut a piece of 1/4" [6mm] foam rubber (not included) 

and place it on the fuel tank tray. Insert the hook and loop 

strap through the slots in the fuel tank tray. Fit the fuel tank 

through the hole in the fi rewall (with the correct side of the 

tank facing up) and use the strap to tightly secure the tank 

to the tray.

❏ 

5. Connect a 6-7" [152-178mm] piece of standard fuel 

tubing to each tube protruding from the fuel tank.

❏ 

6. Install the engine mount side mounted to the fi rewall 

using four 6-32 x 1" [25mm] machine screws, four #6 fl at 

washers, four #6 lock washers and thread locking compound. 

Leave the screws slightly loose. Test fi t your engine between 

the mount halves. Slide the mount halves against the sides 

of the engine and fi nish tightening the mount screws.

❏ 

7. Position the front of the engine drive washer 4-1/2" 

[114mm] from the front of the fi rewall. Mark the location of 

the engine mount holes onto the mount rails using a Dead 

Center Hole Locator. Remove the engine from the mount 

and use a 6-32 tap and drill set to create threads in the four 

mounting holes. Attach the engine to the mount using four 

6-32 x 3/4" [19mm] screws, four #6 fl at washers and four #6 

lock washers.