Lanier R/C MARINER 40 MK II ARF Instruction Manual - page 15

15

❏ 

13. Thread a nylon clevis with silicone clevis retainer 

onto the 17-1/2" [445mm] pushrod. Insert the pushrod 

into the outer pushrod tube. The aft end of the pushrod 

should pass through the screw-lock connector. Attach the 

clevis to the throttle arm. Adjust the pushrod position in the 

connector so that the throttle servo properly opens and 

closes the carburetor. When satisfi ed, tighten the set screw 

in the connector against the pushrod and cut off the excess 

pushrod behind the connector. Use the radio system to test 

the operation of the throttle.

❏ 

14. Use the plywood pushrod clip to secure the outer 

pushrod tube to the fuselage former in the location shown. 

Thoroughly glue the clip in place. Apply some CA glue where 

the outer pushrod tube passes through the fi rewall.

FINISH THE MODEL

Install the Receiver and Battery

❏ 

1. Wrap your receiver and receiver battery pack in foam 

rubber. Make a strap from the remainder of the included 

hook and loop material to fi t both of the components when 

stacked. Strap the receiver and pack to the tray as shown. 

Connect the rudder, elevator and throttle servos to the 

receiver. Connect a Y-harness to your aileron channel.

❏ 

2. Mount your switch harness and charge jack to the 

fuselage side in the location that you prefer.

❏ 

3. The remaining piece of heat shrink should be used for 

the connection between your receiver battery and switch 

harness. Use tie straps (not included) or something similar 

to bundle the excess servo wires out of the way of the servos.