Lassco Spinnit EBM-2.1 User Manual - page 11
Operating Instructions
Leveling The Drill Bits
Page 09
To level the drill bits to the Table, first loosen the
Leveling Knob on the right hand side of the machine
as shown. Pull down on the Handle to raise the Table
until the hollow drill bit is just touching the Drill Strip
(EBM2-1034). Hold the Handle in place and tighten
down the Leveling Knob until it hits the Handle
Bracket. This will stop the Handle from being pulled
down too far. It is important to always reset the Level
with each use. This will make sure you don’t drill into
the Drill Strip, dulling the hollow drill bit.
Step #6:
When you are ready to drill, set the product to be
drilled on the table and make sure it is secure using
the Paper Side Stops. Turn the machine on and
holding the product firmly in place with one hand, pull
down on the Handle raising the Table up to meet the
drill bit. Using one consistent smooth stroke, put
pressure on the Handle so that the Table rises fully
allowing the drill bit to drill through the product. It is
important you maintain a consistent speed through
the entire stack. It is also important you do not go too
slow or too fast. If you drill too slow you can burn the
paper leaving undesired marks. If you drill too fast,
the drill bits will act more like a punch and they will
break or plug.
Step #7:
Note:
We recommend using a piece of card stock on the Table
when leveling the drill bits to avoid drilling into the drill strip.
This will lengthen the life of your drill bits and keep them
sharper.
Drilling
To move the Table to the next desired hole on the
pattern bar, press in on either of the Release Handles
(EZ-1010) located on both ends of the table. Press-
ing in the Release Handle releases the Table Pin
allowing the table to traverse. Release the Handle
and slide the Table until it locks into place in the next
desired position. Repeat Steps #7 and #8 as desired
until complete.
Step #8:
Traversing the EZ-Glide Table
Release Handle
Release Handle
Table