Lassco Spinnit EBM-2.1 User Manual - page 7
Setting Up Your Machine
Table Assembly Installation
Page 05
Grasping the Table and depressing the Release
Handles to unlock the Table Pin, slide the V-Bars
located on the underside of the Table into the
V-Rollers on the Base of the machine as shown.
Step #1
Attach the second Table Stop (EZ-1014) to the
underside of the table using two 1/4” lock washers
and two 10-32 Elastic Stop Nuts as shown. Tighten
with a wrench until secure.
Step #2
Note:
Please note that one of the Table Stops (EZ-1014) comes
installed. Make sure when installing the Table onto the
Base you are sliding it from right to left (while facing the
machine) to avoid obstruction from the pre-installed Table
Stop.
Note:
Please note that, although they are factory set, you may have to adjust the cams on the
V-Rollers if the Table is too tight or too loose after installation. If so, remove the Table.
With an open-end wrench and holding the screw head in place with a screwdriver, adjust
the cam spacers under the V-Rollers. If the Table is too tight, adjust the V-Rollers out
towards the edge of the Fork Plate (EZ-1000). If the Table is too loose, adjust the
V-Rollers in toward the center of the Fork Plate.
V-Bars
Release
Handles
Underside of Table
Table Pin
Table Slide Stop
1/4” Lock Washers
10-32 Elastic Stop Nuts
V-Rollers
Cam Spacers
Fork Plate