Lassco Spinnit EBM-2.1 User Manual - page 8
Setting Up Your Machine
Backgauge Assembly
Page 06
Step #4
Step #3
Paper Side Stops
Attach the Paper Side Stops (FM4-4006) using two
Side Stop Screws (FM4-4007) each. Position the
Paper Side Stop as desired and tighten down with
light pressure.
Step #5
Attach the Backguage to the Table by hooking the left
end over the Side Iron (FM4-4003) on the side as shown
in the accompanying picture. Align both ends of the
Backgauge using the Table Scales (3S-14) so that it is
squared correctly. When it is positioned as desired
tighten down the Clamp Bracket Knob as shown.
Assemble the Backgauge by placing the Black Fiber Washer (EBM-76) over the Threaded
Stud. Place the Clamp Bracket (EZ-1028) on the Threaded Stud with the knob end
toward the center of the assembly. Tighten the Elastic Stop Nut on the Threaded Stud
with a wrench until it is snug, allowing the Clamp Bracket to move with slight resistance.
Note:
Do not position the Backgauge too close to the hollow drill bit
so that it touches. This can cause serious damage to the
hollow drill bit causing it to break or shatter. The Backgauge
must be at least 1/8” from the circumference of the hollow drill
bit.
Clamp Bracket & 1/4” Knob
Black Fiber Washer
5/16”-18 Elastic Stop Nut
Threaded Stud