Lassco Spinnit EBM-2.1 User Manual - page 9
Setting Up Your Machine
Chip Bag
Pattern Bars
Page 07
Your EBM-2.1 comes with five pattern bars
included. Four common patterns and one blank
pattern as shown.
Insert a Pattern Bar by loosening the Pattern Bar
Stop (EZ-1022) and inserting the desired pattern
into the slot on the Pattern Bar Guide as shown in
the diagram. Insert the angled end into the slot as
far as it will go so that the slot at the end of the
Pattern Bar lines up with the Pattern Bar Stop.
When you have the pattern correctly inserted,
tighten down the Pattern Bar Stop through the slot
on the Pattern Bar locking it in place.
Step #7
Electrical Start Up
Making sure nothing is interfering with the drill bit,
plug the cord set into a grounded 115V outlet. To
turn the machine on, press the Rocker Switch on the
upper left hand side of the shroud.
Step #8
2-3/4
3-1/2
2-3/4
4-1/4
Blank (Customizable)
3 holes 2-3/4” apart center to center
3 holes 3-1/2” apart center to center
2 holes 2-3/4” apart center to center
3 holes 4-1/4” apart center to center
(standard three ring binder)
Your Spinnit Paper Drill is now ready for use. With proper operation and
maintenance, it will give you trouble free operation for years.
Attach the chip bag as shown by stretching the
open end over the top hook of the chip chute.
Continue fitting it around the entire edge of the chip
chute making sure it is snug.
Step #6
Note:
Be sure to empty the chip bag regularly as needed. Failure
to empty the chip bag can result in clogging of the chip
chute.
Power Cord
Rocker Switch