Lawn Solutions TR2009HOF1 Operator's Manual - Drive System
Figure 19
1.
Center electrode insulator
2.
Side electrode
3.
Air gap (not to scale)
6. Carefully install the spark plug by hand (to avoid
cross threading) until it is hand tight.
7. Tighten the spark plug an additional 1/2 turn if it is
new; otherwise, tighten it an additional 1/8 to 1/4
turn.
Important: A loose spark plug can become very
hot and can damage the engine; overtightening
a spark plug may damage the threads in the
cylinder head.
8. Connect the wire to the spark plug.
Drive System
Maintenance
Checking the Tire Pressure
Service Interval: Before each use or daily
Maintain the air pressure in the tires as specified. Check
the tires when they are cold to get the most accurate
reading.
Pressure: 46 psi (317 kPa)
1
G003793
Figure 20
1.
Valve stem
Adjusting the Transmission
Service Interval: Before each use or daily—Ensure that
the machine does not creep when the
traction control lever is in neutral.
If the machine creeps either forward or rearward when
the engine is on and the traction control lever is in
neutral, complete the following procedure:
1. Stop the machine on a level surface, place the
traction control lever in neutral, stop the engine, and
raise the cutting blades to the highest position.
2. Loosen the nuts on the transmission control cable
under the traction control handle (Figure 21).
17