Lawn Solutions TR2009HOF1 Operator's Manual - page 9
lever forward or rearward to the desired depth setting
(Figure 9).
Important: Do not pull the lever left or right as this
will bend it.
2
Figure 9
1.
Depth control lever
2.
Locking knob
The center position, with three open holes to the left
of the lever and four to the right) is the zero position
with the blades at the same depth as the bottom of the
wheels. Move the lever reward from there to raise the
blades above ground level or forward to lower them into
the ground.
g013316
1
Figure 10
1.
Zero position
Seeding Rate Gauge
Use the seed rate gauge to set the seed flow rate. It
is calibrated with the machine speed to give you an
even seeding rate at any speed. To change the seeding
rate, loosen the knob on the gauge and move the gauge
pointer to the desired position, then tighten the knob to
hold it in place.
Figure 11
Refer to the seeding graph located on the machine to
determine the correct gauge setting for the type of grass
you are planting and the thickness in which you want
to plant it.
Seeder Control Lever
Push the seeder control lever (Figure 12) forward to start
the seed flow and pull it rearward to stop the seed flow.
Note: The machine is designed so that the seed flow
slows and/or stops when you stop the machine or slow
for a turn. To reduce seed loss raise the front wheels as
the machine is turned. There is no need to turn the seed
flow on and off for each turn.
1
2
G016887
Figure 12
1.
Seeder control lever—Off
2.
Seeder control lever—On
9