Leader 726HS Instruction Manual - page 10
10. Headset Operation.
These instructions are to be used
in addition to the instruction book and on the assumption
the handset is already connected, ready to use.
(1) Connect the telephone headset by plugging into the
socket on the right hand side of the telephone.
If the handset is being used and the headset is required
to be used, press the Headset “on hook button”, then
hang up the handpiece. This will ensure the call is not
disconnected and the headset can be used.
Please seek advice from your supplier for compatibility
of the headsets you intend to use.
By plugging in this headset the “on hook dial button”
automatically becomes a headset on off switch.
The handpiece can remain in the cradle at all times whilst
the headset is being used.
The red LED aluminates when the headset is in use.
(2) Press the headset “on hook dial button” to answer an
incoming call or to obtain dial tone to dial out.
(3) Press the same button to terminate the call.
(4) The volume control on the right hand side of the
telephone can be rotated to increase or decrease the
incoming sound levels.
(5) The handpiece can be used as an option for normal
telephone use whilst the headset is connected. When
the handpiece is lifted the headset becomes inoperable.
10