Leader 726HS Instruction Manual - page 7
3. Battery compartment: Batteries are not required. Memory
retention is permanent when connected to the line. When
disconnected memory retention is 30 minutes.
4. For desktop use: Your phone can be placed on a desk or
table just like any regular telephone.
5. For wall-mount use (over standard USOC RJ-11W modular
wall jack): First, install the separate plastic wall mounting
bracket as shown. This is a simple snap fit. Using the short
line cord, plug one end into the modular jack on the base unit,
and route the cord to the bottom centre of base unit as shown.
Plug the free end of line cord into the wall jack. Position the
base unit so that studs on the modular wall jack fit into the two
wall mounting keyholes. Once in position, slide the phone down
about 1/4 inch to secure the mounting. Lift and rotate the wall
mounting tab in handset cradle to the upward protruding wall-
mount position. Place handset in the cradle to hang up.
WALL MOUNTING WITHOUT STANDARDWALL PLATE
(1) Mount two screws in the wall spaced according to the template
on the margin of this page. Leave a clearance about 1/4 inch
between each screw head and the wall surface. Select screws
of adequate length and size for good fit into the keyholes of
the unit and secured mounting in the wall.
(2) Using the long modular line cord, plug one end of the cord
into the unit and the other end into the wall jack. Route the
cord down the channel on the bottom of the unit as shown.
(3) Position the unit so that the screw heads fit into the keyholes
on the bottom of the unit. Once in position, slide the phone
down about 1/4 inch to secure the mounting. Be sure to lift
and rotate the wall mounting tab on the handset cradle to the
wall mounting position (protruding upwards).
CAUTION:
MAKE SURE MOUNTING IS SECURED BEFORE
RELEASING THE PHONE.
7