Leader YD5558 User Manual - page 17
OCHRONA GAŹNIKA PRZED ZAMARZANIEM
Przy używaniu pilarki w temperaturze od 0 do
-5°C oraz wysokiej wilgotności może wystąpić
oblodzenie gaźnika, co z kolei może spowodować
zmniejszenie mocy silnika lub nierówną
jego pracę. Z tego powodu, pilarka została
wyposażona w klapę wentylacyjną z tyłu osłony
filtra powietrza, która dostarcza ciepłe powietrze
do silnika, zapobiegając oblodzeniu.
W normalnych warunkach pilarkę należy
użytkować w trybie zwykłym, zgodnie z
ustawieniami fabrycznymi. Jednakże, jeśli
istnieje możliwość oblodzenia, należy uruchomić
pilarkę w trybie przeciwoblodzeniowym.
PRZEŁĄCZANIE TRYBÓW PRACY (F16)
1. Wyłącz silnik (O).
2. Zdemontuj pokrywę filtra powietrza i osłonę na
tylnej stronie pokrywy filtra powietrza.
3. Wariant 1 - Przestaw osłonę o 180
°
tak, aby
płytka trybu zapobiegania oblodzeniu znalazła
się po prawej stronie. Ponownie przykręć
pokrywę filtra powietrza. Wariant 2 - Przekręć
czarną pokrywkę plastikową w dół w ten sposób,
aby widoczny stał się otwór w obudowie i ciepłe
powietrze dochodziło do filtra powietrza.
(1) Osłona filtra
(2) Płytka przeciwoblodzeniowa
(3) Śruba
(4) Zwykły tryb pracy
(5) Tryb przeciwoblodzeniowy
(6) Osłona
CARBURETOR ANTI-FREEZE MACHANISM
Operating the chain saw in temperatures of
0-5°at times of high humidity may result in ice
forming within the carburetor, and this in turn
May cause the output power of the engine to
be reduced or for the engine to fail to operate
smoothly. This product has accordingly been
designed with a ventilation hatch the back of
the air cleaner cover to allow warm air to be
supplied to the engine and to thereby prevent
icing from occurring.
Under normal circumstance the product should
be used in normal operating mode, i.e., in the
mode to which it is set at the time of shipment
however when the possibility exists that icing
may occur. The unit should be set to operate in
anti-freeze mode before use.
SWITCHING OPERATION MODE
(F16)
1. Turn off the engine (O).
2. Open the filter cover and open the rear cover
on the filter.
3. Option 1 - Flip the cover 180
O
, so that the
icing protecion plate was on the right side.
Reattach the air filter cover. Option 2 -Turn the
black plastic lid down to let the warm air reach
the air filter through the hole.
(1) Air cleaner cover
(2) Anti-icing plate
(3) Screw
(4) Normal operating mode
(5) Anti-freeze mode
(6) Screen
PL
EN
16
(F16)