Leadtek WinFast 6300MAX/MA Pro User Manual - page 16
Leadtek Research Inc.
12
CPU L2 Cache ECC Checking [Enabled]
Controls the ECC (Error Checking and Correcting) capability in the CPU level 2 cache.
Pentium III Serial Number [Enabled]
Controls the serial number of Pentium III CPU to be detected by Intel Corp.
Quick Power On Self Test [Enabled]
Select Enabled to reduce the amount of time required to run the POST. A quick POST skips
certain steps. We recommend that you normally disable quick POST. Better to find a
problem during POST than lose data during your work.
First/Second/Third Boot Device, Boot Other Device [HDD-0/Floppy/SCSI, Enabled]
This category determines which drive to be searched first, second or third for the disk
operating system (i.e. DOS). You can use these settings to select your Priority Boot Up
drives for Floppy drive A, IDE Hard Disk Drive C, D, E, F, or SCSI.
Swap Floppy Drive [Disabled]
This field is effective only in system with two floppy drives. This item allows you to determine
whether to enable the swap floppy drive or not (i.e. physical floppy disk A assigned to logical
drive B or physical drive B to logical drive A).
Boot Up Floppy Seek [Disabled]
During the “POST” process, BIOS will determine if the floppy disk drive installed is 40 or 80
tracks. 360K-type is 40 tracks. 760K, 1.2M and 1.44M are all 80 tracks. Few modern PCs
have 40-track floppy drives, we recommend that you set this field to “Disabled” to save time.
Boot Up NumLock Status [On]
This field allows you to determine the default state of the numeric keypad. “On”: keypad is
number keys after boot up. “Off”: keypad is arrow keys after boot up.
Gate A20 Option [Fast]
This item defines how the system handles legacy software that was written for an earlier
generation of processors.
Typematic Rate Setting [Enabled]
When this item is set disabled, keep holding down a key on the keyboard will let the system
to use the default typematic rate delay of 250 msec, and typematic rate of 6 chars/sec to
input repeatedly. When enabled, you can adjust both settings. You can use this feature to
accelerate cursor movement with the arrow keys.
Typematic Rate (Chars/Sec) [6]
When “Typematic Rate Setting” is enabled, its selections allow you to select the rate at which
character repeats when you hold down a key.
Typematic Delay (Msec) [250]
When “Typematic Rate Setting” is enabled, its selections allow you to select the delay before
key strokes begin to repeat.
Security Option [Setup]
If you have set a password at USER PASSWORD option in main menu, select whether the
password is required every time the System boots, or only when you enter Setup.
OS Select For DRAM > 64MB [Non-OS2]
Choose OS2 when you are using OS/2 and SDRAM size greater than 64 MB. Choose Non-
OS2 for other operating systems.
Report No FDD for WIN95 [No]
Select “Yes” to release IRQ6 when the system contains no floppy drive, for compatibility with
Windows 95 logo certification. In the Integrated Peripherals screen, select Disabled for the
Onboard FDC Controller field.
You should select “Yes” if your operating system is Windows
95 and without a floppy disk equipped in your computer.
Video BIOS Shadow [Enabled]
Enabled: the contents of the video ROM is copied from ROM to RAM for faster execution.