Leadtek WinFast 6300MAX/MA Pro User Manual - page 23
WinFast 6300MAX/MA Pro User’s Manual
19
KB Power ON Password [Enter]
Allows you to set a password for keyboard powering on.
Power Up by Alarm [Enabled]
Enable this item to set a date and time alarm that will automatically resume the system from
a software power down.
Month Alarm [NA]
Set a month from NA to 12.
Day of Month Alarm [0]
Set a day from 0 to 31.
Time (hh:mm:ss) Alarm [0 0 0]
Set a time for the alarm in hours, minutes, and seconds.
4.7 PnP/PCI
Configurations
The PCI Personal Component Interconnect Bus was developed primarily to address two
important issues: (a) How to allow peripheral devices to take the fullest advantage of the
power of CPU technology, and (b) Provide a simpler installation process for peripheral
devices, such as Network cards, EIDE or SCSI controllers.
PCI accomplishes these goals with its 32-bit Data path Local Bus design, and support for
Plug & Play. Unlike older expansion bus architectures, PCI provides peripherals with a direct
connection to the CPU and memory. The PCI bus runs at 33Mhz and has a maximum
transfer capability of 132MBps. With Plug & Play, the system BIOS automatically determines
hardware resources for new peripherals, simplifying installation of multiple interface cards.
This Setup Menu provides configuration options for the PCI Bus and its assigned resources.
CMOS Setup Utility – Copyright (C) 1984-2000 Award Software
PnP/PCI Configurations
Item Help
Reset Configuration Data
Disabled
Resources Controlled By
Auto(ESCD)
IRQ Resources
Press Enter
PCI/VGA Palette Snoop
Disabled
Menu Level
!
:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit
F1:General Help F5:Previous Values F6:Basic Defaults F7:Best Defaults
Reset Configuration Data [Disabled]
!
Disabled: Normal Setting
!
Enabled: Select Enabled to reset Extended System Configuration Data (ESCD) when you
exit Setup if you have installed a new add-on and the system reconfiguration has caused
such a serious conflict that the operating system cannot boot.
Resource Controlled by [Auto (ESCD)]
!
Manual: The field defines that the PNP Card's resource is controlled by manual. You can
setup whether IRQ-X or DMA-X is assigned to PCI/ISA PnP or Legacy ISA Cards.
!
Auto: If your ISA card and PCI card are all PNP cards. Set this field to "Auto". The BIOS
will assign the interrupt resource automatically.
4.8
PC Health Status
This menu shows the current temperature and voltage, and allows you to set up “CPU
Warning Temperature” and “ Shutdown Temperature”.