M Design LUNA 1000H Instructions For Installation And Use Manual - page 10
OPGELET : Een huis mag nog zo stofvrij zijn, warmtebronnen geven
een circulatie van huisstofdeeltjes. Gedurende de periodes dat men niet
stookt, vormt zich een accumulatie van stof in de flexibels en de roosters.
Bij het stoken kan dit geurproblemen veroorzaken. Het is aangeraden de
flexibels en de roosters af en toe stofvrij te maken ( dmv een stofzuiger ).
Na een paar keer goed doorstoken verdwijnt de geur. Dit fenomeen is te
vergelijken met grijze sporen die tevoorschijn komen boven een gewone
radiator. U kan in optie mooie metalen deksels bestellen bij uw dealer, om
gedurende de zomerperiode de roosters af te schermen.
BELANGRIJK: een circuit van warmelucht vraagt een retour om geen onderdruk in
de kamer te creëren. De openingen aan de achterkant van de haard moeten niet
aangesloten worden aan flexibels. De verse lucht gaat via natuurlijke weg aangezo-
gen worden dankzij het schouweffect van de aangesloten flexibels bovenaan. Een
rooster in de schouwmantel dichtbij de bodem zorgt er dus voor dat koude lucht
kan aangetrokken worden. Al de gebruikte aansluitingen zo goed mogelijk met
gelijke lengte en bochten plaatsen, anders zou het kunnen dat sommige roosters
veel meer warmte geven en andere bijna niets. Daar een warmeluchtbuis hetzelfde
effect geeft dan een schoorsteen, gaat degene die het eerst warm wordt ook de
meeste trek geven waardoor deze nog sneller warm zal worden.
2.6 Ventilator
2.6.1 Installatie
• Verwijder de chamoflexplaten of gietijzer, de bodemplaten en de toegang tot de
ventilator.
• Schuif nu de ventilator naar beneden tot net onder het vuur
• Maak nu de nodige elektrische verbindingen.
2.6.2 Dimmer voor ventilatie
• Laat de regeling van de ventilatiesnelheid toe.
• Zekering 1,5A (De knop afnemen, het plaatje losschroeven, uittrekken voor ver-
vanging.)
• Regelingsschroef voor de min. snelheid onder de knop.
(In optie, M-design ontwikkeld een nieuwe inductie dimmer waarbij de ventilator
geruisloos draait. )
• De ventilator (optie) kan op gang gebracht worden na 15min. branden.
• De ventilator, eerste maal 12 uur op max. snelheid laten draaien om hem in te
werken.
ATTENTION : A house is never 100% free of dust. Heat sources mean that natural dust
particles can collect in ducts and mix with the heat. This dust is accrued occasionally in
the flexible ducting and the convection grills. It is easily removed with a vacuum hose,
and is recommended before the appliance is first used at the end of the summer season.
Dust particles can leave a greyish stain where heat is involved, and is often observed
above more traditional forms of heating. It may be as well to cover the grills during the
summer months when the fire is not in use to reduce the collection of dust particles. These
must be removed when the fire is in use.
Note: a circulation of hot air requires that no under-pressure be created in the room. A grid that is
near the floor (pic 7d) sees to it that cold air can be drawn in. Don’t connect those with a flexible.
Air will find the way to get at the right place. Place all the fittings that you use at the same lengths
and angles if possible, otherwise it is possible that some grids give off more heat than others and,
seeing that a hot air pipe functions in a manner similar to a chimney, the one that is hot first has the
most draught and therefore becomes hot even more quickly.
2.6 Fan
2.6.1 Installation
• Remove the Chamotflex plates, the bottom plates and the opening to the fan. See pic.8.
• Now slide the fan downwards to just under the stove.
• Make the necessary electrical connections.
2.6.2 Variateur pour turbine
•Leave the adjustment of the fan speed closed.
• Fuse 1.5A (Take the knob off, unscrew the little plate, take it
out if it is to be replaced.)
• The adjustment screw for the minimum speed is under the knob.
(M-design has developed a new induction dimmer which lets the fan run noiselessly and which
may be bought as an option.)
• The fan (optional) may be started after the fire has burned for 15 minutes.
• Let the fan turn at the maximum speed for 12 hours the first time to let it run in.
Installatievoorschrift en gebruiksaanwijzing - LUNA DIAMOND / Instructions for installation and use
- 8 -