M Design LUNA 1000H Instructions For Installation And Use Manual - page 7
2.4 Verbrandingsluchttoevoer
Elke verbranding verbruikt lucht. In het geval van een thermische afgeslo-
ten kamer is een aanvullende luchttoevoer noodzakelijk. In elk geval moet
men vermijden een onderdruk in de kamer te scheppen. Als de aanwezig-
heid van een dampkap in een aanpalende kamer absoluut noodzakelijk
blijkt, zal een voldoende luchttoevoer voorzien worden om elke onderdruk
te vermijden ( kijk eveneens na of de dampkap voorzien is van een verse
luchttoevoer )
Om een goede werking van de haard te hebben , moet een verse luchttoe-
voer voorzien worden van buiten, vanuit een geventileerde schacht of een
geventileerd lokaal (kelder).
Bij de Luna DIAMOND haarden wordt de verse lucht voor de verbranding recht-
streeks aangevoerd van buiten via een flexibel aangesloten op één van de twee in-
gangen. Deze zijn voorzien aan de linker en rechterzijde onder het toestel. Dankzij
dit uniek systeem is de lucht , nodig voor de verbranding, volledig gescheiden van
de convectie luchtstroom in de leefkamer.
De haard wordt altijd geleverd met één open verse luchaansluiting. Indien u wilt
veranderen, hoeft u enkel de plaat los te vijzen aan waar u wilt aansluiten en deze
op de andere opening terug te plaatsen. Indien onderaan niet aangelsoten kan
worden, moet in optie een adaptor besteld worden.
2.4 Air supply for combustion
Every form of combustion uses air. In the case of a thermally sealed room supplemen-
tary air supply is essential. One must at all times avoid creating under-pressure in the
room. If a cooking hood appears to be absolutely essential in the adjoining room,
sufficient air supply will have to be provided to avoid every form of under-pressure.
You need an airlet with dia. 150mm coming from outside, or a ventilated shelter. This
air inlet you have to connect to the Luna.
With the Luna Diamond, the fresh air for combustion is supplied directly from outside
through a flexible ( dia. 150mm ) that is connected to one of the 4 entrances that
are provided on the left, right or lower side of the fireplace ( pic. 4 & 5 ) . Use for this
purpose one of five connection pieces ( pic. 6 & 7 )
Thanks to this new system, the air that is required for combustion is completely sepa-
rated from the convection air stream in the room ( see further at point 2.3. Convec-
tion current ).
The appliance is always delivered with an open air inlet at the left side. If you want
to change, you can remove the plate on the side you wish to connect and replace
the plate on the side that was open before.
ø
150
Openingen voor aanvoer externe lucht
Opening for arrival external air
Alle/all Luna Diamond H, 550V, 850V
1 x
ø
150
Alle/all Luna Diamond DH, DV, 1000V
en 1150V
2 x
ø
150
Installatievoorschrift en gebruiksaanwijzing - LUNA DIAMOND / Instructions for installation and use
- 5 -
aansluitstuk /
connection part
verse lucht van buiten of kelder
fresh air arrival from outside or basement
ingang convectie
convection inlet
uitgang convectie
convection outlet
adaptor aansluiting zijkant /
adaptor side connection