MA Lighting dot2 XL-F User Manual - page 161
© 2016 MA Lighting T e chno lo gy Gm bH | Da chde ck e rstr. 16 | D-97297 W a ldbütte lbrunn | Ge rm a ny
P ho ne +49 5251 688865-27 | suppo rt (a t) m a -do t2.co m | www.m a lighting.co m
1 of 1
E.g. you have a selection of fixtures at a dimmer value of 50% and you want to lower it 20%. Here's what you type
(you have already selected the fixtures):
At
-
2
0
Please
That would do the trick.
There's a little extra function to the
-
key. If you press it twice it automatically take 10% off the value. So you
could have archived the same by pressing the
-
key four times.
Absolute value or relative value
The description above is about setting a relative value. You can also set an absolute negative value on attributes like
pan and tilt.
The difference between a relative or absolute value is a space between the minus sign and the number.
To set a relative value you could write in the command line
at - 5
(execute command by pressing
Please
). An
absolute value would be written
at -5
(execute command by pressing
Please
).
If you want to use the keys, then you can press
At
-
(hold it while you type the value)
5
Please
, Holding the
minus while typing the value removes the space between the sign and the value.
Using the calculator (you can get this by a short tap on the encoder for the value you want to set) you can tap the
+/- button to add the sign without a space. For relative values you can use the - button.
Page selection
You can use the
-
key to change the active page. If you want to go to the previous page you can use the
following keys:
Page
-
Please
You can also use calculations. If you are on page five and want to go to page two you could use the following keys:
Page
-
3
Please
Related links
6.40. Move key
161