Mackie TT System 32 Owner's Manual - page 31

Mackie TT24 Digital Live Console Owner’s Manual Addendum v1.7

31

DS3232 on a Card Slot SEND

This example shows the U100 Slot B: SEND set up in exactly the same way as shown for the 

Slot A: RECEIVE on the previous page:

Here we have set the U100 Slot B SEND channel 1 so it will send only the DS3232 signal that 

corresponds to our selections. Card B Send is ready to send DS3232 signals.

You will notice that when you select the DS3232 as your send, the U100 Slot A: RECEIVE will 

also change to the same selection. This auto-fi lling-in of the receive side only happens if you 

are sending a signal that does not originate from the host console. The card is getting ready to 

send something it doesn’t have, so it gets ready to fi nd and receive it fi rst.

If, in the above example, we now set up to send a TT24 FOH Master signal, the receive side 

will not change:

TT24 on a Card Slot RECEIVE

DS3232

1

Input

1 to 32

Pre-Fader

Select TT24, and the choices are: 

FOH Master

FOH Slave

MON Master

MON Slave

Each of these selections has extra menus as 

shown in the next few pages of this guide: