Mackie TT24 Owner's Manual - 6.1 Tt Control Conventions

33

Owner’s Manual

Owner’

s Manual

Figure 6-1 TT Control software screen

Ch 6: Touchscreen and TT Control

6.1 TT Control Conventions 

The TT control software expands the TT24’s control 

possibilities by providing: 

•  Remote control of all functions from a PC connect-

ed via USB 

•  Improved metering and graphics than can be dis-

played on the Touchscreen 

•  Remote Venue/Preset management and con-

sole–>console backup/restore 

•  Console firmware upgrade capability 

•  Detailed Snapshot management 

Most of the TT24’s configuration occurs on the Touch-

screen and/or the TT control software. This section 

discusses the general conventions for both interfaces. 

Since the TT control software screens mirror and elabo-

rate the Touchscreens, they will not be discussed except 

to define their functional differences. 

In both the Touchscreen and TT control, the 

Ctrl

 key 

has a useful function: Press and hold the 

Ctrl

 key and 

adjust any TT control parameter to restore its default 

value. For example, press and hold 

Ctrl

 and adjust a 

Pan knob to set it to the center position, or adjust an EQ 

Gain knob to set it to 0 dB. 

NOTE:

 The Touchscreen and TT control screens 

can be synchronized, so displaying a new 

screen on one displays the corresponding 

screen on the other, or independent, allowing 

two engineers simultaneous access to the 

console. They are synchronized by default. See 

page 46 to toggle this setting.