Mackie TT24 Owner's Manual - System

58

TT24 DIGITAL LIVE CONSOLE

TT24 DIGIT

AL LIVE C

ONS

OLE

Appendix C: TT24 Console Surface Quick Keys

SYSTEM

Hard Reset = CTRL+HELP on power up

Pressing and holding these two buttons on power up will hard reset the TT24 to factory default settings. This will 

also clear all internal memory deleting all snapshots, presets, and venues.

Soft Reset = CTRL+UTIL on power up

Pressing and holding these two buttons on power up will soft reset the TT24 to factory default settings. This will 

NOT clear all internal memory. Therefore, all snapshots, presets, and venues will remain intact.

Manual LCD Calibration = CTRL+SETUP

Pressing these two buttons simultaneously while the TT24 is already powered up will activate the LCD calibration 

screen. If the touchscreen does not allow proper action on button presses this allows for easy recalibration of the 

screen.

RESET FUNCTIONS

Reset Channel = CTRL+ FAT

Pressing these two buttons will reset the selected channel to default settings.

Reset EQ = CTRL+ EQ

Pressing these two buttons will reset the selected channel’s EQ to default settings.

Reset Dynamics = CTRL+ DYN

Pressing these two buttons will reset the selected channel’s Comp/gate to default settings.

Reset Group and Auxes = CTRL+ GRP/AUX

Pressing these two buttons will reset the selected channel’s group assignments to OFF, and auxiliary send levels 

to OFF.

Reset all Channel Auxes = CTRL+ AUX 1-12

Pressing the CTRL button plus any individual aux number button (1-12) will reset all channels’ aux sends to off. 

Very useful for clearing an aux mix.

TT Control Special Screens

Matrix Overview = CTRL + MTRX

Pressing these two buttons will cause the TT control application to display a matrix overview screen.

Bank Meters = CTRL + METERS

Pressing these two buttons will cause the TT control application to display a high-resolution meter screen of the 

currently selected bank.

96 faders = CTRL+ any bank button (ANLG, DGTL, RTNS, MSTR)

Pressing these two buttons will cause the TT control application to display a 96 fader screen where all channels 

of the mixer are viewable on one screen.

EXTRAS

Global V-Pot Gain Reduction Meters

Press and hold the METERS button for 2 seconds and all V-Pots will convert to gain reduction mode where the 

LEDs show gain reduction metering and the knob controls threshold. This can be done on a individual channel 

basis by putting the V-Pots in meters mode and pressing the the encoder. The red LED at the bottom of the V-Pot 

indicates gain reduction mode when in METERS.