Mackie TT24 Owner's Manual - 6.14 Utility

49

Owner’s Manual

Owner’

s Manual

6.14 Utility  

Figure 6-32 UTILITY MENU SELECTION

Press the 

UTIL QuickMix button to open the UTILITY 

MENU SELECTION Touchscreen. Touch the 

MONI-

TOR SOURCE, STEREO INPUT ASSIGN, TALKBACK, 

METERING, TEST TONES, and USER BANK buttons 

to configure those attributes. 

6.14.1 MONITOR SOURCE

Figure 6-33 UTILITY MONITOR SOURCE

The MONITOR SOURCE Touchscreen assigns a source 

for the monitor outputs and the headphones. The moni-

tor analog gain controls are located in the UTILITY 

area (see page 18). Choose among these sources: 

L/R, 

C/MONO, DIGITAL, TAPE/CD A, or TAPE/CD B. 

The 

L, R, and C meters mirror the hardware meters 

and display the 

L, R, and C/M Monitor outputs. Each 

meter has an overload LED at the top. 

The 

SOLO LEVEL adjusts the level of the solo group. 

It varies ±15 dB in 0.1 dB increments and its default 

level is 0 dB. The 

RUDE SOLO LED lights when a chan-

nel is soloed. 

6.13.2 TALKBACK

Figure 6-34 UTILITY TALKBACK

Select the desired Matrix and Aux channels to enable 

for Talkback. 

By default, the Talkback button operates in a latching 

manner. Press the talkback button on the mixer to en-

gage the input and the button illuminates. Press again 

to disengage and the button turns off. The talkback but-

ton can be changed to operate in a momentary (push to 

talk) method by deselecting the talkback latch button 

on the TT control or LCD via UTILITY/TALKBACK.

6.14.3 STEREO INPUT ASSIGN

Figure 6-35 UTILITY STEREO INPUT ASSIGN

This screen routes the selected stereo input (

DIGI-

TAL, TAPE/CD A, or TAPE/ CD B) to the main mix. 

SOLO 

Activate the 

SOLO button to cue the signal prior to 

routing to the speakers. 

MONO 

Activate the 

MONO button to send the summed mono 

signal to both the 

LEFT and RIGHT outputs.