Magma EB3600-AB User Manual - page 125
Magma
EB3600-AB | Chapter 7 Rack Slide Installation
125
Secure with 2 screws to both front and rear posts. After you have secured the slide rail fingers to the rack
posts, tighten the 2 screws used to attach slide rail B to the end bracket D.
Attach Chassis to Slide Rail / Rack (STEP 6)
CAUTION
Install the system as low as possible into the rack enclosure. For best stability, do not install the
system above equipment that weighs less than it does.
CAUTION
The system is heavy, it weighs about 60 lbs. In the following procedures, two people are
required to move the system. Two people are also required to align and install the slide
assemblies into the rack.
Extend slide piece C out until the safety catch engages. Do this for both sides. Next, insert the slide rail A
inside the grooves on slice part C as shown below. Push in until it stops.
Next, press on the safety Latch on slide piece A and continue to push until it stops again. Press on the safety
catch again to allow the chassis to slide all the way into the rack.