Magnadyne PL70 Installation manual - page 11
11
Transmitter Code Learning
To Enter Code Learning Mode: [The Module Learns Up To 4 Transmitter Codes]
1. Turn on the ignition key.
2. Depress the program switch [3] times within 30 seconds. after turning ignition key.
3. The horn will emit [1] long chirp to indicate you are now in code learning mode.
4. Depress the “LOCK” button on the 1st transmitter.
5. The will horn will emit [1] short chirp.
6. Depress the “LOCK” button on the 2nd transmitter.
7. The horn will emit another short chirp.
8. Repeat the above steps [4] & [5] for the 3rd and 4th transmitter if applicable.
9. Turn off the ignition key. The horn will emit [1] short and [1] long chirp to indicate you are out of code learning.
Note: If a 5th transmitter is programmed in, it erases the 1st transmitter etc.
To Erase the Codes of A Lost or Stolen Transmitter:
1. Enter transmitter code learning as usual.
2. Depress the “LOCK” button on your one remaining transmitter [4] times.
3. Alternatively you can purchase an additional transmitter and program in the [2] transmitters twice each etc.
4. The idea is to fill the memory bank with [4] codes to delete the old codes.
About Feature Programming
To simplify the procedures we have divided the feature programming into 4 groups. Please review the factory settings and
decide if you require any changes.
Basic Overview On How to Perform Feature Programming:
• Turn on the ignition key.
• Depress the program switch the appropriate number of times to select the group of features you want to change.
• Depress the “LOCK” and/or “UNLOCK” button to change the feature.
• Turn off the ignition key.
• The factory default settings is always [1] parking light flash and [1] horn chirp.
• Therefore, when you first depress the “LOCK” or “UNLOCK” button on the transmitter, it advances the module to the
next feature setting.
• In this case, the module would advance to [2] parking light flashes and [2] chirps.
• Simply keep re-depressing the transmitter button again until the module advances to your desired setting.
Chirp Feature Programming
To Enter Chirp Feature Programming:
1. Turn on the ignition key.
2. Depress the program switch [6] times within 30 seconds. after turning on ignition key.
3. The parking lights will flash [6] times. The horn will chirp [6] times.
4. You are now in Feature Programming for Chirps.
Chirp Status: [Factory Default Setting is ON]
The horn normally emits [1] horn chirp upon a remote lock and [2] chirps upon a remote unlock signal. You can
permanently program these chirps off, if desired:
To Turn the Chirps OFF:
• Depress the “LOCK” button.
• The parking lights will flash [2] times. The horn will chirp [2] times.
To Turn the Chirps Back ON: [Factory Default Setting]
• Depress the “LOCK” button.
• The parking lights will flash [1] time. The horn will chirp [1] time.