Magnadyne PL70 Installation manual - page 3
Yellow Wire with White Stripe: [Ignition 2 Output]
• Provides [+] 12 volts while cranking and while running on remote control.
• Some vehicles have [2] ignition wires that must be powered.
• Connect to the vehicle's 2nd ignition wire that goes hot in the start and remains hot in the run position. If this wire is
not used, cap the end of the wire.
Red Wires: [2 Constant +12 Volts Inputs]
• Receives constant [+] 12 volts from the vehicles battery +12V hot wire[s].
• Connect both of our red wires to the vehicle's [+12] volt battery source wire.
• The two red wires have a 20 amp fuse in each wire. Both wires must be connected.
Yellow Wire: [Ignition 1 Output]
• Provides [+] 12 volts while cranking and while running on remote control.
• Connect to the vehicle ignition wire that goes hot in the start position and remains hot in the run position. This
yellow wire must be connected.
10 Pin White Connector
Cavity #1 Vacant: [Relay Coil Power]
• This vacant cavity sends out [+12 volts] at all times to activate a relay coil. [86]
• For trunk/hatch pop applications, we suggest you use our optional ALA-RPT.
• Insert the terminal on the red wire of the ALA-RPT into cavity #1.
• Insert the terminal on the black wire of the ALA-RPT into cavity #8.
Cavity #2 Gray Wire: [Pulsed Ground Output for Car Horn Panic Feature]
• The gray wire provides a pulsed [-] output to beep the vehicle's existing horn.
• Connect the gray wire to the vehicles [-] trigger wire that goes to the horn relay.
Warning! Maximum output on this wire is 300ma. Horn systems requiring a [+] voltage or more than 300ma to
trigger the horn relay will require an additional relay.
Cavity #3 Blue/White Stripe Wire: [Tach Input Wire]
The blue/white wire sends the vehicle's tach data to the control module.
• The blue/white wire is used for tach mode only.
• If used, connect the blue/white to the vehicle's coil [-] wire.
• No connection of this wire is required, if you use the voltage mode.
Cavity #4 Brown Wire:
• Not Used
Cavity #5 Blue Wire: [Hood Switch Input]
• The blue wire turns off the remote starter when it sees a ground signal.
• Connect the blue wire to one wire of the hood safety switch.
• Connect the other wire of the mercury hood switch to ground.
Cavity #6 Green Wire:
• Used to allow proper operation of the automatic door-locking and unlocking feature on vehicle’s with (-) dome
lights.
• If used, connect to vehicle’s (-) door trigger wire.
Cavity #7 Violet Wire:
• Used to allow proper operation of the automatic door-locking and unlocking feature on vehicle’s with (+) dome
lights.
• If used, connect to vehicle’s (+) door trigger wire.
3
Installation (continued)