Magnadyne PL70 Installation manual - page 13
To Enter Remote Starter Feature Programming:
1. Turn on the ignition key.
2. Depress the program switch [10] times within 30 seconds. after turning on ignition.
3. The parking lights will flash [10] times. The horn will chirp [10] times.
4. You are now in remote starter feature programming mode.
Remote Run Time with Gas or Diesel Engine: [Default is 14 minutes and Gas Engine]
The module can be programmed for a 14 or 21 minute run time. In addition, the delay before cranking is programmable
for a gas or diesel engine. Gasoline engine setting is [5] second delay before cranking. Diesel engine should be set for
[18] second delay.
For 21 Minute Runtime with a Gasoline Engine:
• Depress the “LOCK” button.
• The parking lights will flash [2] times. The horn will chirp [2] times.
For 14 Minute Runtime with a Diesel Engine:
• Depress the “LOCK” button.
• The parking lights will flash [3] times. The horn will chirp [3] times.
For 21 Minute Runtime with a Diesel Engine:
• Depress the “LOCK” button.
• The parking lights will flash [4] times. The horn will chirp [4] times.
To Program the Module back to 14 Minute Runtime with a Gasoline Engine: [Factory Default Setting]
• Depress the “LOCK” button.
• The parking lights will flash [1] time. The horn will chirp [1] time.
Starter Release Circuitry: [The Factory Default Setting is Voltage Mode]
You can program the Remote Starter for voltage, tach or fixed cranking time mode.
For Tachometer Mode:
For Tach mode, you must program our module to look for a tach signal. In addition, you must connect our blue/white tach
wire to the vehicle tach wire.
To Select Tach Mode:
• Start the engine with the ignition key and wait for the RPM's to slow down.
• Depress program switch [10] times to enter Remote Start Feature Programming.
• Depress the remote transmitter UNLOCK button.
• The parking lights will flash [2] times. The horn will chirp [2] times.
• Depress and hold in the program switch to learn the [RPM] tach signal.
• [The Parking lights will be on steady while learning the RPM's]
• Once the module learns the RPM's, parking lights will flash [10] times. The horn will chirp [10] times.
• Release the program switch and turn off the ignition key to exit tach learning.
To Select Fixed Starter Cranking Mode:
• Depress the remote transmitter “UNLOCK” button.
• The parking lights will flash [3] times. The horn will chirp [3] times.
To Program the Remote Starter Back to Voltage Mode: [Factory Default Setting]
• Depress the remote transmitter “UNLOCK” button.
• The parking lights will flash [1] time. The horn will chirp [1] time.
Note: In voltage or fixed cranking time mode you will not have an over rev turn off.
It does not matter if the tach wire is connected or not. If the tach wire is connected, you can program back and forth from
voltage to tach mode, as desired.
Remote Starter Feature Programming
13